Springfield XD Forum banner
1 - 1 of 1 Posts

14 Posts
Discussion Starter · #1 · (Edited)
--Sold pending funds--

I have a NIB Drop in Trigger kit and set of laser cut black rubber grips for a Springfield XDM 9mm or 40. I installed this same kit and grip in my .45 XDM and the improvement is remarkable. These were easy to install and the grips look as good as the day I installed them. This is the same trigger kit which Springfield Custom shop uses in their upgrades.

Every XDM should have these options.

The trigger kit and grips sell for over $140 plus shipping. I'll take $120 shipped for these, cheaper than just the trigger kit alone without shipping.

This Drop in Trigger Kit fits all XDM pistols including the new XDM5.25". The kit contains our famous striker safety lever, to remove the long trigger pre-travel on the XDM trigger. Reduced power: trigger spring, sear spring, striker safety spring and striker spring, to lower the pull weight. Our trigger is made of tough light weight polymer that helps speed up the reset. It also has an integral over travel stop on the back of the trigger. Using this method of over travel stop removes added stress on the trigger bar that are present with any of the other over travel stop methods. This trigger is a Springfield Armory OEM part available on production XD and XDM pistols from the factory (see APPENDIX D4 21.6 Production Division Rules). When installed correctly, the kit will give you a short crisp trigger pull (about 3.5-4.5lbs) with a fast reset and shorten the total trigger pull length. Fits all XDMs.

PRP Ultimate Easy fit XDM Trigger Kit
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.