Springfield XD Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
309 Posts
Discussion Starter #1
My gun is on the way to Geneseo for the Lockblock cracking issues. Should I replace the Don's Guide Rod with the stock Recoil Spring before sending it? I don't want to give them any excuse for not repairing the gun. I know that Don says there is no correlation, but I don't want to take a chance. What are your thoughts?
 

·
Registered
Joined
·
2,078 Posts
I have not had any isses with the block cracking and I use Don's rod, so I see no corellation between using the rod and locking block failure. However, many manufacturers like to use after market modification as a reason not to honor warranties, so I would put the stock part back in. If you still have it, it just takes a couple of minutes and removes a source of worry. You can always put Don's rod back in when it comes back.
 

·
Registered
Joined
·
309 Posts
Discussion Starter #4
R/T Performance said:
If you have it swap it out but no worries if you already shipped it 8)
I haven't shipped it yet, so I will put in the stock recoil spring. Thanks.
 
1 - 4 of 4 Posts
Top