Springfield XD Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
66 Posts
Discussion Starter #1
I was comparing my XD-40 Tac to my buddies G20. My XD is only about 3/8" longer and all of that is from the trigger guard to the end of the barell. They seem to be the same length from the front of the trigger guard to the rear of the slide.
The reason I bring this up is that I'm thinking of picking up an Accumold G20 holster real cheap but I'm not sure my tac will fit.
Is there enough play in the thumb strap and holster to accomodate?
Thanks
 

·
Registered
Joined
·
2,251 Posts
It will not fit a form-fit holster because the disassembly lever increases the frame width too much.

The Accumolds are a good bit more forgiving though, since they're basically padded nylon.
 

·
Registered
Joined
·
124 Posts
I've got a bianchi accumold belt slid made for a Glock 20 that also carries my XD357 service model very well. Nice tight fit on the xd with just a little room for movement. I just have to adjust the strap about 1/3 inch.

G20
 
1 - 4 of 4 Posts
Top