Springfield XD Forum banner

1 - 13 of 13 Posts

·
Super Moderator
Joined
·
22,195 Posts
Any .308 will work.
 

·
Super Moderator
Joined
·
22,195 Posts
.310-.315...308 will work, but its a tad small. Russian 7.62 is .310-.312
Rather have a tad bit smaller than a tad bit bigger:shock:

I have been using it for my 7.62 x 54. Seems to work fine for me.
 

·
Super Moderator
Joined
·
22,195 Posts
It does, but then run a 310-312 through it and see what you pull out....
Do they make that? Do you have a link?

I have only seen it for .308/30-30, 30 cal, etc.
 

·
Registered
Joined
·
18,141 Posts
I use the same one in my AK and mosin.

its the... .30 cal rifle (?) version. it seems a bit tight but not like the one for the .22. the .22 version I need to really pull to get it though. sometimes I pull it so hard I think I am gonna snap it off in there.
 

·
Registered
Joined
·
1,175 Posts
I use the .32 cal. It hasn't hurt anything.
 

·
Super Moderator
Joined
·
22,195 Posts
Its the 8mm one... its on their website, you can also use an 8mm bore brush for 7.62.
But does the .4 mil matter on a bore brush? I woudnt think so but I have never tried it.
 

·
Premium Member
Joined
·
9,171 Posts
the lands are .309-312....how you gonna get in the grooves?? 8mm brushes. I have a 7.62 NATO cleaning kit and it does not 'clean' 7.7 ***, 303 Brit, or any 7.62 ComBloc (except some Finns) as well as a 32 cal brush/mop because it can't reach in the grooves.
 
1 - 13 of 13 Posts
Top