Trigger guard install on Bushy ORC

1289 Views 5 Replies 4 Participants Last post by 2001Stroke, Nov 15, 2008

2001Stroke

Discussion Starter · Nov 14, 2008

This is my first AR and I want to install a magpul trigger guard on my Bushmaster ORC. I can get the roll-pin out but how do I get the other end of the trigger guard out. Sorry about the ignorance! Thanks for any help.

Save

1 - 6 of 6 Posts

spyderman2k4

· #2 · Nov 14, 2008 (Edited)

Take a tool (small punch) and put it in the hole on the right side of the receiver. Push in the plunger and you should be able to remove the trigger guard... unless I completely misunderstood your question.

Save

John A.

· #3 · Nov 14, 2008

Half of the OEM trigger guard is a plunger spring loaded type deal so you can swing it down when you're wearing gloves.

Save

mvician

· #4 · Nov 14, 2008

Be sure to SUPPORT the rear trigger guard "ear" when you are tapping out the old, and in with the new.

Save

spyderman2k4

· #5 · Nov 14, 2008

mvician said:
Be sure to SUPPORT the rear trigger guard "ear" when you are tapping out the old, and in with the new.

Yeah, it'd be pretty depressing to break that off from not supporting it.

Save

2001Stroke

Discussion Starter · #6 · Nov 15, 2008

I got it installed. Thanks for the help!

Save

1 - 6 of 6 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month