Springfield XD Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
17 Posts
Discussion Starter · #1 ·
im a little worried about cutting the poly out of the mag-well for the installation of the mag-well smart lock. I have the 9mm service xd and cutting it for this concerns- Has anybody done this yet, and can you tell me the right procedure so i dont f*+k it up... THANKS- mike
 

·
Premium Member
Joined
·
1,089 Posts
I am not familiar with what you mention. Do you have a URL?
 

·
Registered
Joined
·
2,126 Posts
If your talking about the little plastic one thats U shaped, and having to cut out the small amout of U shaped plastic inside the hollow grip hole, then No its not a big deal, and doesn't hurt anything... and you only have to smooth it out only about an inch or inch and a half deep...
 
1 - 3 of 3 Posts
Top