Springfield XD Forum banner

1 - 7 of 7 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
i just bought a tango down vertical grip for my ar and an insight m3x light with a pressure switch. the vertical grip has a pocket for pressure switches but it is much too small for the insight switch. any suggestions...? the grip is too expensive to modify and trimming the pressure switch doesn't seem to be a good choice either. has anybody ran into this problem? any suggestions would be greatly appreciated!!!!!!!!
 

·
Banned
Joined
·
6,667 Posts
There are 2 different models.....you should have gotten the model for the Insight tape switch instead of the SureFire.

TangoDown

Sell that one and buy this one.
 

·
Registered
Joined
·
2 Posts
You might want to contact Tangodown to let them know your problem, if the grip is still in new condition, they might just do a switch for you so you can get the model with the Insight switch pocket....


hope this helps.
 

·
Registered
Joined
·
902 Posts
Uh-oh! Now that SMGLee is here we will all be broke in a few days :)
 
1 - 7 of 7 Posts
Top