Springfield XD Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
7 Posts
Discussion Starter · #1 · (Edited)
I just installed a PRP spring kit on my XDs. Got the springs installed, and back together. But after getting it back together, the trigger is in the cocked position but will not pull. Not sure where I went wrong. I followed the PRP install video exactly. My problem is, if I can't get the trigger to pull, I can't remove the slide to take the gun back apart. Any tricks like reaching a punch in to drop the sear like on a XD? Sorry, I think I put this in the wrong section.
 

·
Registered
Joined
·
417 Posts
I had the same issue. Try removing the striker locking plate and the striker. This freed up the slide for removal. Seems that I had assembled it wrong.

Sent from my SCH-I545 using Tapatalk
 

·
Registered
Joined
·
5 Posts
I had the same problem, it was the over travel being a bit to far out took it in just a hair and it fixed the problem, was with a xd 4" service by the way
 

·
Registered
Joined
·
12 Posts
Yup, the grip safety arm is in the wrong position, been there done that. Make sure you position the arm ABOVE the PIN but BELOW the SEAR. I found out the hard way also.
 
1 - 4 of 4 Posts
Top