Springfield XD Forum banner

1 - 6 of 6 Posts

·
Registered
Joined
·
469 Posts
Discussion Starter #1
Well i had my bottom built. i just got my dpms pardus stock.

i try to put it on im on the last step... putting in the spring then tightening the nut

but the spring WONT FIT?

So i look things over... and im guessing i used the spring for the GRIP right now.. and the one for the stock was used for the grip ;/

has anyone done this
 

·
Registered
Joined
·
469 Posts
Discussion Starter #2
23 views and not one reply lol come on

do u guys think this is the problem? i dont have tools here to see if that is ;/
 

·
Registered
Joined
·
324 Posts
I assume you are talking about the safety detent spring versus the rear takedown detent spring. Yes, I guess it would be possible to reverse them, but if you tested the safety selector, you should have noticed something was wrong. That spring is easy to remove by just pulling the grip off so it should be an easy fix.
 

·
Premium Member
Joined
·
2,267 Posts
has anyone done this
NO!

Ok. I viewed this but didn't figure it applied to me 'cause I never put together a lower.

So I didn't think I should answer since it didn't apply to me. :)

So again......................my answer is NO! :lol:
 

·
Registered
Joined
·
469 Posts
Discussion Starter #6
lol those 2 springs next to eachother look identical
 
1 - 6 of 6 Posts
Top