Springfield XD Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
10 Posts
Discussion Starter #1
I have some questions on Stag Arms model 3 rifle with the plus package. I am set on getting this rifle but need to know a little more about it from those of you that have it. I have the following questions about the model 3:
1. How accurate is it?

2. How reliable is it?

3. What are the rails that go to the diamondhead v-rs handguards made of, polymer or aluminum?

4. Can any rail be used with the v-rs handguards?

5. Any magpul magazine compatability issues?

Any help is appreciated.
 

·
Registered
Joined
·
2,744 Posts
I have some questions on Stag Arms model 3 rifle with the plus package. I am set on getting this rifle but need to know a little more about it from those of you that have it. I have the following questions about the model 3:
1. How accurate is it?
Not sure but if it's made from Stag I'm sure it would suffice.

2. How reliable is it?
My Stage 2T ate everything I put through it so I would say very reliable.

3. What are the rails that go to the diamondhead v-rs handguards made of, polymer or aluminum? Anodized 6061  T6 aluminum

4. Can any rail be used with the v-rs handguards?
These V-RS Drop-In Rail System

5. Any magpul magazine compatability issues? No

Any help is appreciated.
There you go. :D
 

·
Registered
Joined
·
10 Posts
Discussion Starter #3
Thanks. The question that was frustrating me the most was the material the rails were made of. I knew that the handguards were aluminum but wasn't sure if the rails were too. I guessed that the v-rs handguard would take only the the v-rs rails but it never hurts to ask, especially since each full size v-rs rail section is $22.

Does the model 3 come with a gun case if you buy from the company online?
 

·
Registered
Joined
·
2,744 Posts
My Stag came with a hard case so I'm sure your's will as well.
 
1 - 4 of 4 Posts
Top