Springfield XD Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
229 Posts
it will do both ... i reload 9mm and 40 and .270 win . i dont load my .270 on it anymore cause i use a single stage press to be more presice and exact on the numbers .. but if you want to reload pretty quickly then that would be great .. it comes with a 3 hole turret and i upgraded to a 4 hole turret because the lee die set i have has four dies , the 4th one being the factory crimp . i also got the lee safety prime to make the priming go a little faster .. it comes with a holder for small primers and large primers as well . and i also got the lee auto disk powder measure with the swivel attachment and the die extender for it to clear the lee safety prime which bolts to the frame and not the turret action . the auto disk is not accurate with the table it comes with but it is very accurate with dispensing the very same amount of powder every time so make sure you measure the grains and dont go by the table .. just use as a starting point for the grains to the powder you are using and measure the 1st twenty rounds or so . ill just do about 10 in a small bowl really quick and then start measuring from there .. the 1st 10 will be way off and then it will start to get better . other than that, it has worked very well for me and i hope it will give me a million more loads of realoading . hope this helps any

benjamin
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top