Springfield XD Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
6 Posts
Discussion Starter #1
Just finished up installing the kit, the trigger feels much better! It releases the striker and reset feels good. I just have a question though.

I noticed the sears range of motion is much less than the movement was when stock, should I keep sanding down the triggers integral over travel stop until I get more movement? Or will this limited motion be just fine when shooting?
 

·
Registered
Joined
·
480 Posts
Push down on the rear of the slide with constant pressure while pulling the trigger. If the sear releases the striker with that, you don't need to to sand any more. That should cover any variance you might encounter.

That trigger is nice isn't it?!
 
1 - 2 of 2 Posts
Top