Springfield XD Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
Has anyone had an issue with powder river precisions after market extractor? I installed their extractor (which is a bit longer than the stock part) and have had 3 failure to eject in about 600 rds. The end result is a round partially pulled from the barrel and the slide stuck open from pushing a fresh round into the back of the spent brass. I have been shooting a mix of factory ammo Winchester, federal, etc 115gr so I don't think it is an ammo issue.

Thanks for the help!
 
1 - 2 of 2 Posts
Top