Springfield XD Forum banner

1 - 7 of 7 Posts

·
Registered
Joined
·
5,000 Posts
Discussion Starter · #1 · (Edited)
Finally got a hold of some Gen M3 Coyote PMAGS. Wasn't so much looking for the color as I was curious about the updated follower geometry. Round does sit up a bit higher versus older PMAGS. They also sit higher vs the GI mags with the M193 follower in them. Looks like a lot of thought went into them. I haven't had time to really vet them properly but I've run them in a Colt, BCM, and a few other rigs without issue. Rounds sit about the same height as a GI mag with the M855A1 follower.

Material seems harder than other Gen M3 offerings. That's the best way I can describe it. Also, the color isn't solid throughout as there's a few light spots on it. Definitely darker than FDE. Pics are as follows:

1) M3 MCT, M2 FDE, M3 MCT in natural light

2) M3 MCT, M2 FDE in artificial light

3) M3 and GI mag (With M193 follower) loaded with 62gr OTM's

Edit: Forgot to add that they insert on a closed bolt much easier than Gen 2's and Gen 1's. Even easier than the Gen 3 Black windowed models I have. No effort at all.

IMG_1210.JPG
IMG_1213.JPG
IMG_1212.JPG
 
  • Like
Reactions: DevJames and Spike

·
Registered
Joined
·
5,000 Posts
Discussion Starter · #3 ·
All mags look like that side by side.
 

·
Registered
Joined
·
5,000 Posts
Discussion Starter · #5 ·
Lè magic

IMG_1215.JPG
 

·
Registered
Joined
·
9,888 Posts
Do they come in a steel lined AK version?

If so, I'll take....... one.
 
1 - 7 of 7 Posts
Top