Springfield XD Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
21 Posts
Discussion Starter #1
I installed the PRP trigger kit in XDM 3.8 but I am having a problem assembling it. I have everything installed and when I attempt to put the slide on it wont lock down. As I turn the disassembly lever it forces the slide forward. If I try to hold the slide in place the lever will only go down to about 45 degrees. I thought it was an issue with the new trigger so I changed it back to the original one (just the Trigger) and it still wont latch.
I appreciate any help.:?
Thanks
 

·
Registered
Joined
·
21 Posts
Discussion Starter #2
Never mind!
 

·
Registered
Joined
·
21 Posts
Discussion Starter #4
It must have been a burr or crud on something. Not sure but I took it back apart sprayed everything down with gun scrubber and put it back together. Everything went together smooth and works great. Going to the range in the morning to test it out.
 
1 - 4 of 4 Posts
Top