Springfield XD Forum banner

1 - 9 of 9 Posts

·
Registered
Joined
·
7 Posts
Discussion Starter #1
HI all,

I'm new to shooting - first handgun - XD MOD 2 SC 9mm. As you can see by the image below, one of the trigger pins is sliding out. I bought the gun new and have put 300 rounds through it. It has been moving slowly out...

Is this normal? Should it be moving out?
I assume I can slowly tap it back in, but haven't done anything yet.

triggerpinxdmod2sc.jpg
 

·
Registered
Joined
·
5,000 Posts
You can just pop it back in but it shouldn't be walking out like that. If it keeps happening there's probably a trip to the mothership in its future.
 
  • Like
Reactions: klav

·
Registered
Joined
·
7 Posts
Discussion Starter #3
Thanks for your reply, I was thinking the same. Is there nothing holding it in? It's just nice and snug there in the frame?
 

·
Registered
Joined
·
1,777 Posts
Sounds to me like it is a retainer clip issue as the other poster stated. I have had mine out numerous times and when you push it back in you should here a definite click.
 

·
Registered
Joined
·
7 Posts
Discussion Starter #6
I pushed it back in and I heard it click. So let's see how long it takes to move out again...
 

·
Registered
Joined
·
907 Posts
I pushed it back in and I heard it click. So let's see how long it takes to move out again...
If you confirmed the CLICK then it's probably good to go. Happy shooting!
 
  • Like
Reactions: klav

·
Registered
Joined
·
7 Posts
Discussion Starter #8
Thanks! Going to put 100 or so through it next week. Hoping it stays put!
 
1 - 9 of 9 Posts
Top