Springfield XD Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
15 Posts
Discussion Starter · #1 ·
I am planning on using a 10"(10 3/16) Midwest Industries ff handguard on a bcm 14.5" upper, pinned A2x, with a mid length gas system. Going to grind down the fsb...

Does anyone know how far the very end of the fsb is on the barrel? I don't mind if a tiny bit of the fsb sticks out, but I don't want to see half of it, or the gas tube stick out of the handguard.

I prefer the look of the 10", but if it exposes too much of the fsb, I will have to return it and go 12".
 
1 - 1 of 1 Posts
Top