Springfield XD Forum banner

1 - 6 of 6 Posts

·
Registered
Joined
·
70 Posts
Discussion Starter #1
OK, I've searched to no avail to find instructions for XD mag disasembly. Can anybody point me to where they are. I shot my first USPSA match yesterday with my stock XD-9 Tactical and now my mags are full of sand. I need to brush them out. I've disassembled several differed types of mags before, so I can probably figure it out, but it's always best to read up on it first.
 

·
Registered
Joined
·
452 Posts
Look on the bottom of the mags there should be a small round button that you push in and then slide the base plate forward. I use a pen or something similar.
 

·
Registered
Joined
·
298 Posts
Look at the bottom of the mag. There is a little circle in the middle of that black plate.

Push that circle in with a punch or something.

Slide the plate off the bottom

Watch the spring and locking plate will fly out if your not carefull

Your done!
 

·
Registered
Joined
·
84 Posts
I know these are old posts, but I wanted to say thanks anyway. I just installed a GeePlate finger extension on my XDs 45. That was easy compared to removing the baseplates on my Glocks.
 
1 - 6 of 6 Posts
Top