Springfield XD Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
7 Posts
Discussion Starter #1
Hello everyone, I'm new here but have owned an Xd since '02. I am trying to replace my mag release button. I used a 1/16 punch to remove the roll pin out but must have pushed it too far?? I cannot get the pin back through. I have it half way out, also, the mag release button never came out either...any suggestions would be greatly appreciated...thanks
 

·
Registered
Joined
·
7 Posts
Discussion Starter #2
ok, i got the mag release button out but cannot get the roll pin back through..it is only half way out, not all the way, any help please??
 
1 - 3 of 3 Posts
Top