Springfield XD Forum banner

1 - 13 of 13 Posts

·
Registered
Joined
·
9,948 Posts
Discussion Starter #1
We picked up some of the first shipments of all the versions of these Guide rod lasers.
All three models in stock and ready for shipment.
LMS-4XD40 For: Springfield 4" XD .40
LMS-4XD9/357 For: Springfield 4" XD 9mm, .357
LMS-5XD For: Springfield 5" XD .40, 9mm, .45GAP

http://www.xd-hs2000.com/shopping.html
 

·
Registered
Joined
·
2,244 Posts
WOW that look sweet!

WOW that looks expensive!

How do you turn it on and off? Does it have a momentary switch somewhere? Does it have some way to adjust for point of impact?

Thanks
mcb
 

·
Registered
Joined
·
146 Posts
Can you use normal replacement springs from wolf with one of these?
 

·
Registered
Joined
·
9,948 Posts
Discussion Starter #4
You can not use other manufactures springs these are assemblies.
here are some pictures
you turn it on with the disassembly lever (red arrows)





 

·
Registered
Joined
·
1,582 Posts
Right [email protected]!in on! My prayers have been answered.
Is the turn off switch hard to install? Do have to remove anything stock?
 

·
Registered
Joined
·
9,948 Posts
Discussion Starter #6
Fatmatt you will have to remove the stock disassembly lever but even if you had a problem I could talk you through it. Also they have good directions, you can have the rod fully installed in about 5 min if you do it slow.
 

·
Premium Member
Joined
·
3,598 Posts
Do these work on first generation 2000's by chance?

Bryan
 

·
Registered
Joined
·
9,948 Posts
Discussion Starter #9
bran I am not sure about that, but they all can use the same guide rods and assemblies.
 

·
Premium Member
Joined
·
3,598 Posts
Couldn't find an answer to this and may be a stupid one but is a hs2000 first generation considered a 4" or 5" when it comes to and xd equivilant?

Like if I'm ordering a holster do I look for a 4" or 5" when they say it will fit an xd.


Thanks,


Bryan
 

·
Registered
Joined
·
9,948 Posts
Discussion Starter #11
Your HS2000 would be the 4 inch or service model. Thats not a stupid question, its better to ask then get the wrong equipment for it.
 

·
Registered
Joined
·
5 Posts
Got one for my 5" 9mm. It is dead on!! You simply replace
the takedown assembly with the one supplied in the kit, Pop in
the laser guide rod and Shazzam your up and running.
The "switch" is easily activated from either side.

Total time to install - about 1.5 min......But read the directions!

I have about 800 rounds on the system. I shoot the gun in
production class and leave the laser in. (not using it obviously
in the match)

DVC
 

·
Premium Member
Joined
·
3,598 Posts
Thanks james, always willing to help. I like that.
 
1 - 13 of 13 Posts
Top