Springfield XD Forum banner
1 - 7 of 7 Posts

·
Registered
Joined
·
268 Posts
Discussion Starter · #1 ·
I was wanting to get some laser etching, but the barrel is not thick enough. Below is a pic of what I am wanting, but out barrels aren't as think as that. Does anyone make a thicker barrel or is that even possible?

What I want done:





Our barrel:





Side by Side:

 

·
Registered
Joined
·
174 Posts
I've never heard of anybody doing a bull barrel on an XD, you would have to be able to open the slide up and increase the entire barrel diameter. Basically I don't think it's possible because could then cause interference of the recoil spring and rod as well.
 

·
Registered
Joined
·
268 Posts
Discussion Starter · #5 ·
I've never heard of anybody doing a bull barrel on an XD, you would have to be able to open the slide up and increase the entire barrel diameter. Basically I don't think it's possible because could then cause interference of the recoil spring and rod as well.

This is my thinking as well... :(


Maybe you could put it on the slide?

Yeah I was thinking that too, but it looks so cool on the tip of the barrel itself... but if it can't be done, it can't be done.

real tiny script necessary, but readable to the reader
heck, engrave the end of a bullet, with a smiley face
Yeah....
!

Maybe with a 9mm conversion barrel in a 40?
I have a 45 ;)
 
1 - 7 of 7 Posts
Top