Springfield XD Forum banner
1 - 5 of 5 Posts

· Registered
Joined
·
2,642 Posts
Discussion Starter · #1 ·
receiver came in today, now just need to tig weld it, modify the semi auto shelf to allow the paddle mag release lever, and order my 7 compliance parts tomorrow. YAY!


By passmedagreen
 

· Registered
Joined
·
2,642 Posts
Discussion Starter · #3 ·
so far have budgeted up about 450 bucks, and still need another 150-200 in compliance, but its worth it. this kit had been sitting at my dads house for over two years. when i bought the kit its was around 250 bucks, right now they are selling for 500+
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top