Springfield XD Forum banner

1 - 7 of 7 Posts

·
Registered
Joined
·
334 Posts
Discussion Starter #1
Hey all,

Do you remove your EOTech from your upper everytime you clean your rifle?

-Tim
 

·
Registered
Joined
·
224 Posts
not usually but i did once to remove the front handguard, cause i mounted my xps hanging over the delta ring. put it back on and there was no shift in my 50 yard zero.
 

·
Registered
Joined
·
1,373 Posts
No, I try to not touch any scope/EOTech/Aimpoint/ACOG once its zeroed. Even if it has a Larue mount which is known to get you back to zero. I try to avoid taking them off even when cleaning.
 

·
Registered
Joined
·
839 Posts
Yup...

Then again I have an EXPS 2.0 that has a quick disconnect mount. It was guaranteed to hold zero and hold zero it does. If it will lock back in place every time I figure why not pop it off every time I'm done with it...
 

·
Premium Member
Joined
·
9,363 Posts
i dont see the need to take it off during cleaning, I dont. Mine was a couple inches off when i remounted one on my rifle I had to send back to the factory.
 
1 - 7 of 7 Posts
Top