[komot]

Bought a Hellcat and decided to get an Apex trigger.
Spent a few hours disassembling and reassembling the gun...almost.
The little horseshoe device and tiny spring is driving me crazy.
I inserted the tiny spring several times but when trying to install the device beck into the grip module it tends to pop out.
I think my wife, a retired AF Major, learned some new words today.

I'll do it again tomorrow but if anyone has some suggestions, other than just junking the whole thing and buying another P365, let me know.
When I get it back together I may just head to the LGS and dump it.

I'm not new to this stuff...replaced triggers on quite a few guns...just cause I could.
Part of the problem is arthritic fingers due to age...>85...but never saw any design like this.

Suggestions???

 

[komot]

Not quite at that position yet...but...last Springfield...

 

[komot]

I should have mentioned that my Hellcat has the manual safety.
A lot different setup than the non manual safety.
Seems like an afterthought. The spring in question provides tension for the safety.

 

[komot]

Sorry it's giving you fits. I think I had mine installed in about 10 minutes and it feels great. I was an Armorer for 20 years so that didn't hurt I reckon. No reason to trash a great platform. Give it you bestest shot.

Bestest???
Where did you go to school???
Oh...missed the Marine thing.

 

[komot]

Guess I'm too old to look at little men in the moons with smiles, frowns, winks...what ever they are called.

 

[komot]

Lou,
Why would you even think I needed someone to tell me there was a video of the Hellcat.