dont know what else to try for an XD-9 not extracting.

1870 Views 19 Replies 8 Participants Last post by 9mm lover, Jan 13, 2005

polarbear

Discussion Starter · Jan 8, 2005

I have been having problems with my 4" XD-9 extracting. I had a box of Winchester white box 115 grain and about every other one would not extract the brass and jam up. I have heard of using other ammo but i think it should be about to use any ammo i put in there. I heard lubing and under-lubing might help. My last resort before switching out the extractor is that i heard you can have extraction problems if you have limp wrists. Can anyone explain this to me please.

Save

1 - 3 of 20 Posts

9mm lover

· #4 · Jan 8, 2005

How many rounds do you have through it? Has this happened from day one?

Save

9mm lover

· #18 · Jan 13, 2005

I'm no expert, but remember that the case rim has to be able to slide between the extractor and the breach face as the round is stripped from the magazine. If the extractor was designed to hold the round very close to the breach face, is it possible it would prevent the back of the brass from sliding up the breach face?

Save

9mm lover

· #20 · Jan 13, 2005

I just posted about a Q&A I read that stated that the extractor groove on WWB in the 100 round packs is different from the extractor groove on WWB in the 50 round box. It also stated that the 100 round boxes tend to cause FTEs on individual guns regardless of make or model.

No more 100 round WWB for me. Even if I know a problem is ammo related I'm afrait it will undermine my confidence if problems occur.

Save

1 - 3 of 20 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month