Springfield XD Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
6,742 Posts
Evidently the new belt is wider than the clip. Take the belt off and run it into the empty holster to see how much too wide the leather is to fit the clip. If you are lucky it could be close enough that you can press (squeeze) the clip over the belt to the closed position. If you can do that it should stay clipped during a draw, if not, as you say you will need either a narrower belt or a wider clip. If all else fails if you want to make it fit you could notch the bottom of the belt. (not really recommended, but it will work)
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top