Springfield XD Forum banner
1 - 5 of 5 Posts

· Registered
86 Posts
Discussion Starter · #1 · (Edited)
I'm selling my Bi-Tone XDM 5.25 in .45. It has all the extras as listed below. $850

New Slide and extractor installed by Springfield in August (I have about 300 rounds on the new slide with no issues)
Tungsten Guide rod (I'm also including the original and a steel guide rod)
PRP Extended Grip Safety
Canyon Creek Stainless Steel magwell
Canyon Creek B1 Extended magazine release
The trigger was done by PRP its at about 2 1/2 pounds
PRP Stainless Steel Pin Set
PRP Striker Retainer Pins (1 is in the gun now and I have 2 additional)
Grip texture was done by PRP
PRP Titanium Striker Safety Kit
PRP Titanium Striker Status Indicator Kit
PRP XD/XDM mag-release spring
While PRP had it they also re-crowned the barrel and polished the feed ramp

It also includes
5 original/Springfield 13 round magazines with Pistol Gear Bump Pads
6 Canyon Creek 18 round magazine repair kits
2 Arredondo spring kits (no tubes, they are designed to fit the factory tubes)
1 Blade Tech dropped and offset holster
The original Springfield holster
3 original Springfield magazine pouches
The original Springfield loader
lot of additional original and upgrade parts
Oh, and of course the original case

Cash only, no trades.
Shipping will be considered but the buyer pays for FedEx priority overnight to the FFL.

1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.