Springfield XD Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
26 Posts
Discussion Starter · #1 ·
i know you can get a replacement barrel to make a 40cal XDM a 9mm. can you get a 40cal barrel to swap out in a factory 9mm? hope this makes sense.

thanks.
 

·
Registered
Joined
·
6,161 Posts
You need what is called a conversion barrel. The hole in the end of the slide that the barrel goes through is bigger on the .40 than on the 9mm. The conversion barrel has the same outer diameter as the .40 barrel, but the chamber and inner barrel diameter of the 9mm.
 
1 - 3 of 3 Posts
Top