[Killbilly]

Brother, if there's any way you could take a picture of your gas block (with the gas piston removed, just like for normal cleaning) I would be forever grateful.

I hope you figured it out and can help me

 

[Killbilly]

just a pic of o ring in correct groove would be wonderful

 

[Killbilly]

Nobody out there has a VR60?

the o ring was damaged but still in the groove, im sure it was the groove closest to the chamber end not the barrel end

 

[t.dalton2316]

Oh thank goodness!!!
I found a broken rubber O ring on the threaded post that holds the recoil spring and no one (including the manufacturer) can tell me where it goes. I'm pretty sure it goes inside the gas block it self. Here are some pics. The 1st is the o ring 2nd where I found it and 3rd is a picture of the gas block. I put one o ring in one of the slots (red box) for illustrative purposes.
And again, thanks for answering.

Put one in both. its just stopping the gas from going the wrong way. and for the break in, i just left my bolt locked open for about a month and after the secound mag she fed fine on 2 3/4in 7.5 one ounce shot.

 

[bencov3]

I have a VR60 and have the same problem with it feeding low brass. Not to mention trying to load low brass into the magazine. I've not see an issue with my o-rings.

 

[Mark38090]

My VR60 eats everything I put in it.

 

[bencov3]

Took the VR60 out this weekend and it ran great. Not sure what the issue was last time around but absolutely no issues this weekend.

 

[Mark38090]

Good news