[Sunfish]

My pistol has done this since purchased. Has quite a few Springer parts installed and still does it. It's the Thumb Safety 4 inch model and does not group well at all. I'm waiting on a reply from Springer Precision. Didn't want to send it all the way to Oregon but I don't know anyone in the middle TN area that is a XD guy. It shoots every time but acts like it's not fully in battery. I have never taken the extractor out or tried to tune it but I'm suspicious of it. I welcome comments and suggestions

 

[6.0 Tech]

Try xd man, he’s in Alabama according to the website, not entirely sure where in the state, but definitely closer to you than oregon


Sent from my iPhone using Tapatalk

 

[Texan-XD]

This is a pretty common problem, I collected brass at my last range visit, and the guy's Glock next to me was leaving swipe marks on the primer. I would say if it's not causing a problem, then just leave it alone.

 

[HngnHunter]

Many do the primer wipe but the non-centered strikes and poor accuracy makes me wonder what’s up. Does the barrel shroud come up evenly with the top of the slide?

 

[Sunfish]

It appears to be even. If anyone is interested Springer no longer has in house support. So if you buy any parts from them you are on your own

 

[HngnHunter]

It appears to be even. If anyone is interested Springer no longer has in house support. So if you buy any parts from them you are on your own

Is the chamber centered with the bore? Does an unfired round fit in the chamber moderately snug? Doesn’t flop around much? With the gun positivity empty if you look down the bore (you can use a mirror) is the firing pin centered in the bore?