Springfield XD Forum banner

ar15

  1. Rebuild time

    AR Talk
    I've had this BCM barrel sitting around for a while. Had it in an Aero upper but their tolerances weren't very tight. Barrel slid in with no resistance. I shot it a few times and it was all over the place for accuracy. BCM had a sale on their demo/blem uppers last week so I scooped one up...
  2. WTB: Free Float Handguard

    Want To Buy
    I am looking to buy a free float rail for my next upper project. Has to be either 12" or 13.5" and for an AR-15. One piece free float with mounting hardware. Can be a quad rail or M-lok. Troy, Midwest, Aero Precision, Odin Works and such. Figured I'd give this a shot before I go retail in...
  3. I built a rifle

    AR Talk
    I picked up a few lowers over the last few months and decided to start doing stuff with them. In my quest to do stuff I came across another lightweight lower for a price I couldn't say no to. After acquiring it I decided to build the lightest rifle I could without dropping 2k. The result will be...
  4. Need ideas on fluted bull barrel's

    AR Talk
    I'm not sure if this is the right section to post this so if not please do not hang me. I am looking for any help on companies that make a QUALITY Wylde 223/5.56 16 inch fluted bull barrel. Any and all help would be appreciated. Once again if this is the wrong forum to ask this question I do...
  5. WTS: Barely used Palmetto State AR .308 with lots of extras

    Other Firearms for Sale
    FOR SALE IS A BARELY USED PALMETTO STATE ARMORY AR-10 .308 WITH LESS THAN 25 ROUNDS FIRED THROUGH IT AND IT SHOWS. COMES WITH FRONT AND REAR MAGPUL MBUS, FAIL ZERO NICKEL BORON BOLT CARRIER AND BOLT, AXTS RAPTOR TUNGSTEN CHARGING HANDLE, 15' MIDWEST INDUSTRIES HAND GUARD, 2 MAGPUL 20 ROUND...
Top