Refinishing my Old Model Super Blackhawk

Discussion in 'XDTalk Chatter Box' started by ArmyBound, Dec 26, 2010.

  1. ArmyBound

    ArmyBound XDTalk 500 Member Founding Member

    Joined:
    Jun 23, 2009
    Messages:
    871
    Likes Received:
    0
    Trophy Points:
    16
    Location:
    Ft. Irwin, Ca
    Ratings:
    +0 / 0
    [​IMG]I am wanting to refinish my Super Black Hawk to it's original condition. I was hoping someone with some experience could point me in the right direction as to who to send it to and how much it will cost. It has some holster wear at the tip of the barrell, one spot on the barrell is rough its smaller than a pencil eraser. Also where the ejector rod rubs the barrell needs to be finished. I also love the jeweling on the hammer but it's rubbed smooth on half the hammer on one side. Any info or advice would be much appreciated.

     

Share This Page