PW striker retainer pin & sear & trigger springs

Discussion in 'XD Gunsmithing and Maintenance' started by Sam1234, May 10, 2017.

  1. Jun 13, 2017 #11
    XDJyo

    XDJyo XDTalk 100 Member

    Joined:
    Apr 8, 2012
    Messages:
    110
    Likes Received:
    18
    Trophy Points:
    18
    Ratings:
    +44 / 1
    I measured the replacement roll pins and they all measured .1330" (+/-). Much bigger than the .123 mentioned by Sam1234. I'll send an e-mail to Springer Precision about that and see what's up.
     
  2. Jun 14, 2017 #12
    Sam1234

    Sam1234 XDTalk Member

    Joined:
    Jun 17, 2016
    Messages:
    68
    Likes Received:
    19
    Trophy Points:
    8
    Ratings:
    +63 / 0
    Not sure of the quality of your digital caliper. My micrometer good quality and very repeatable. What does your digital caliper say the stock roll pin diameter is? That might give you a good idea of the difference between your stock pin and the new pin. Even if the exact numbers do not match what I measured it will let you know the order of magnitude with regard to the difference you are seeing.

    I did find PR to be responsive.

    Good luck and I am interested is hearing what you find out.
     
  3. Jun 14, 2017 #13
    XDJyo

    XDJyo XDTalk 100 Member

    Joined:
    Apr 8, 2012
    Messages:
    110
    Likes Received:
    18
    Trophy Points:
    18
    Ratings:
    +44 / 1
    Well, the stock OEM roll pin is already back in the gun. But it was visibly smaller that the Springer Precision part. I got a response from them from my question. I'll post later tonight.
     

Share This Page