Help putting back together-Mag release

Discussion in 'General SA-XD/XD(M) Talk' started by JoeBob, Dec 21, 2008.

  1. JoeBob

    JoeBob XDTalk 100 Member

    Joined:
    Nov 27, 2008
    Messages:
    101
    Likes Received:
    0
    Trophy Points:
    0
    Location:
    Hays, Kansas
    Ratings:
    +0 / 0
    I searched a bit on here, but didn't find the answer. I bought my XD45 used, and it had the extended mag release. While carrying IWB, it will release the magazine. I must just have a bony back or something, but it hits it just right. I acquired a stock mag release, and went to put it in and ran into an issue.

    I didn't hold the magazine catch tight enough and it slipped out of its normal position. I now have a spring, mag catch, pin, and stock mag release to get put back together. I want to make sure I put it back in correct, but also it is a bear to get back in there. Anyone have any tips/tricks to getting it put back together?
     
    Last edited: Dec 21, 2008
  2. agalindo

    agalindo XDTalk 15K Member Founding Member

    Joined:
    Jun 25, 2004
    Messages:
    16,131
    Likes Received:
    25
    Trophy Points:
    0
    Location:
    Alpine Texas
    Ratings:
    +25 / 0

Share This Page