a newby needs some more help , again . - XDTalk Forums - Your HS2000/SA-XD Information Source!

rimshot · 12-13-2006, 10:33 PM

recently posted a problem with ftf because of fireing pin extended during chambering of round , Deb at Springfield said to return it and issued a RGA , not being in a hurry to ship my xd45 tac back, decided to check for broken fireing pin retainer roll pin , upon complete disassemble found roll pin broken as suspected. Dial caliper says .75 in long ,and NOT 3/32, or 1/8", diameter . Have I wandered into Metric specs here ? Possible to be special diameter ? Gentlemen ,any suggestions to it's specs will be greatly appreciated. As always thanks for helping an old Newby keep the fire burning!

jednp · 12-13-2006, 10:40 PM

Here, check out Don's post in this thread. he has the size posted for the pin, and also a way you can get some free from him.

XD-9 Question about slide

rimshot · 12-13-2006, 11:20 PM

man , I look foward to a long search for the answer and WHAM, minutes away from the answer at my fingertips !!! E mailed Don , pins probably be at my door in no time ,, Thanks Jednp, Keep the fire going .. rimshot

jednp · 12-13-2006, 11:27 PM

Quote:

Originally Posted by rimshot

man , I look foward to a long search for the answer and WHAM, minutes away from the answer at my fingertips !!! E mailed Don , pins probably be at my door in no time ,, Thanks Jednp, Keep the fire going .. rimshot

that's what is so great about this forum. you can ask a question, and the majority of the time people go out of their way to help you find the answer and get it to you as quickly as possible.

12-13-2006, 10:33 PM	#1
rimshot XDTalk Newbie Join Date: May 2006 Posts: 20	a newby needs some more help , again . recently posted a problem with ftf because of fireing pin extended during chambering of round , Deb at Springfield said to return it and issued a RGA , not being in a hurry to ship my xd45 tac back, decided to check for broken fireing pin retainer roll pin , upon complete disassemble found roll pin broken as suspected. Dial caliper says .75 in long ,and NOT 3/32, or 1/8", diameter . Have I wandered into Metric specs here ? Possible to be special diameter ? Gentlemen ,any suggestions to it's specs will be greatly appreciated. As always thanks for helping an old Newby keep the fire burning!

12-13-2006, 11:20 PM	#3
rimshot XDTalk Newbie Join Date: May 2006 Posts: 20	You forum members are super!! man , I look foward to a long search for the answer and WHAM, minutes away from the answer at my fingertips !!! E mailed Don , pins probably be at my door in no time ,, Thanks Jednp, Keep the fire going .. rimshot

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

12-13-2006, 10:40 PM	#2
jednp XDTalk 4K Member Join Date: Jan 2006 Location: Omaha, NE Posts: 4,691	Here, check out Don's post in this thread. he has the size posted for the pin, and also a way you can get some free from him. XD-9 Question about slide