XD Talk

  • Home
  • Forum
  • Active Topics
  • Gallery
  • Social Groups
  • Search
  • Today's Posts
  • Mark Forums Read
  • Register
  • Advertise

Shooting low what should I do?

This is a discussion on Shooting low what should I do? within the SA-XD/XD(M) Range Reports forums, part of the Information category; I have been shooting for about a year now and I am frustrated with my shots . I have a 9mm XDm and a 9mm ...


Reply
Old 11-07-2009, 10:27 PM   #1
XDTalk 100 Member
 
fjdwheat's Avatar
 
Member #: 32951
Join Date: Jan 2009
Location: Iowa
Posts: 308
Question Shooting low what should I do?

I have been shooting for about a year now and I am frustrated with my shots . I have a 9mm XDm and a 9mm SC (shooting better with the XDm). My problem is that I am shooting low all the time. I do not think I am anticipating the shot I am really trying to let the shot suprise me. The target that says what you are doing based on the area that you are shooting says I am breaking my wrist, I do not really understand what that means.

I have tried to hold the gun tighter and stiffer so I do not break my wrist, but holding it to tight I start to shake a little, I am not shooting low but I have to get real tight grip that is uncomfortable to shoot and I fatigue to quickly and start to shake a lot. There has to be something else I can do strength is not a problem it has to be a form issue. I am not doing something right.

I am easily shooting inside a paper plate at 50ft but low. Groupings are usually desent (a stray once in a while).

Need a little help, suggestions.
__________________
He hates these cans! Stay away from the cans!
fjdwheat is offline   Reply With Quote
Remove Ads
Old 11-07-2009, 10:42 PM   #2
XDTalk 1K Member
 
Jarhead1987's Avatar
 
Member #: 30452
Join Date: Nov 2008
Location: Wichita, Kansas
Posts: 1,323
Sight Alignment or you are anticipating the recoil.

Get some snap caps or training rounds and mix them up in your mag. It works best if someone else loads your mag for you.

If the gun dips down especially when you hit a training round, you are anticipating. If that is the case, you should start performing a lot of dry firing to cure that.

It is common for your hand to start shaking after a few seconds. When that happens, just relax, take a few breathes and shake out your hands.

Keep training. You will get better.
Jarhead1987 is offline   Reply With Quote
Old 11-07-2009, 10:45 PM   #3
XDTalk 100 Member
 
Member #: 40556
Join Date: Oct 2009
Location: northwest, florida
Posts: 128
aim higher?
Ocadmirer is offline   Reply With Quote
Old 11-07-2009, 10:48 PM   #4
XDTalk 100 Member
 
dondavis3's Avatar
 
Member #: 40452
Join Date: Oct 2009
Location: Dallas / Forth Worth Area
Posts: 390
Here's some excellent advice from a good shooter :

+1 Steve M1911A1
Senior Member

"I recently read something that immediately made me say, "Yes! Of course."
The thesis was that your trigger technique is much more important than your sighting technique. Your eyes will "automatically" take care of the sighting process, but you have to train your body, hands, and trigger finger to properly press (not "squeeze") the trigger. "Sighting errors" are almost always due to faulty trigger control!
The trigger of any gun—rifle, pistol, or shotgun—should be pressed straight back. Any sideways, upwards, or downwards pressure will cause an inaccurate shot. Further, the press should be smooth, not jerky or intentionally quick.
Work on your trigger press. Your eyes will take care of themselves."

I fully agree with this point of view.



Take a look at "wheel" image toward the bottom of this page. Finger placement is the key, but also how you stroke the trigger.

Accuracy Hints

I hope this helps
dondavis3 is offline   Reply With Quote
Old 11-07-2009, 11:56 PM   #5
XDTalk 500 Member
 
ericc40's Avatar
 
Member #: 40558
Join Date: Oct 2009
Location: High Point, NC
Posts: 831
Quote:
Originally Posted by dondavis3 View Post
Here's some excellent advice from a good shooter :

+1 Steve M1911A1
Senior Member

"I recently read something that immediately made me say, "Yes! Of course."
The thesis was that your trigger technique is much more important than your sighting technique. Your eyes will "automatically" take care of the sighting process, but you have to train your body, hands, and trigger finger to properly press (not "squeeze") the trigger. "Sighting errors" are almost always due to faulty trigger control!
The trigger of any gun—rifle, pistol, or shotgun—should be pressed straight back. Any sideways, upwards, or downwards pressure will cause an inaccurate shot. Further, the press should be smooth, not jerky or intentionally quick.
Work on your trigger press. Your eyes will take care of themselves."

I fully agree with this point of view.



Take a look at "wheel" image toward the bottom of this page. Finger placement is the key, but also how you stroke the trigger.

Accuracy Hints

I hope this helps
good info!!!
__________________
Mossberg 835 Ulti Mag w/TacStk
Springfield XD9SC SS
H&K USPc9 SS V1
Ruger LCP
Kimber Ultra Ten CDP II
Custom AR-15
Kimber Custom II TLE/ RL[SOLD]
Springfield XD9S[SOLD]
Taurus PT745SS[SOLD]
Taurus PT1911SS[SOLD]
Walther P22 w/Laser[SOLD]
ericc40 is offline   Reply With Quote
Old 11-08-2009, 12:01 AM   #6
XDTalk 100 Member
 
dondavis3's Avatar
 
Member #: 40452
Join Date: Oct 2009
Location: Dallas / Forth Worth Area
Posts: 390
Thank you.

Yes it is - I got it from several people and places.

They did well.
dondavis3 is offline   Reply With Quote
Old 11-08-2009, 12:05 AM   #7
XDTalk 5K Member
 
Member #: 25129
Join Date: Apr 2008
Posts: 5,625
You're flinching. Lots of shooting with dummy rounds mixed in will fix it.
__________________

To view links or images in signatures your post count must be 5 or greater. You currently have 0 post(s).
Joeywhat is offline   Reply With Quote
Old 11-18-2009, 06:10 PM   #8
XDTalk 100 Member
 
Member #: 27361
Join Date: Jul 2008
Location: Southern Illinois
Posts: 263
Once you make sure you are doing all you can SA may be able to help. I bought a XDm9 and it was shooting about 15 inches high. After I confirmed from a rest that it was not me I sent it to SA and they replaced the rear sight and it now shoots 6 O'Clock hold at 25 yards.

FYI
__________________
_____________________________
Festina Lente, Make haste slowly
zmmnm3 is offline   Reply With Quote
Old 11-18-2009, 06:24 PM   #9
XDTalk 100 Member
 
Member #: 30023
Join Date: Nov 2008
Location: Western CT
Posts: 485
I've found that the best way to confirm that it's you, and not the gun, is to hand it to a known good shooter and let them take a few shots. If they're on target, you know it's you. If they're shooting consistantly low, it may be a sight problem. All shots on a paper plate is not bad shooting at 50 feet.
__________________
Springfield Custom XD-9 Service
W/Combat Carry Trigger and Heinie Straight Eights
Kahr PM-9
Mossberg 590A1 9 shot w/ghost rings, M9 bayonet
Remington R-25 .308
rexracer is offline   Reply With Quote
Old 11-18-2009, 06:29 PM   #10
XDTalk 1K Member
 
digitalexplr's Avatar
 
Member #: 21370
Join Date: Oct 2007
Location: Jefferson City, MO
Posts: 1,415
Also ensure you are not using too much or too little trigger finger. Your trigger should hit mid way between your finger tip and first joint.
__________________
P229
P226
Mossberg 590a1
NRA Life Member
digitalexplr is offline   Reply With Quote
Reply

Lower Navigation
Go Back   XDTalk Forums - Your XD/XD(m) Information Source! » Information » SA-XD/XD(M) Range Reports


Search tags for this page

does shoot low pt1911ss 9mm

,

rob leatham tips

,

why am i shooting low


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On