OMG this thing is sooooooo bad ass!!!!
I just picked up this full metall M200 Cheytac Intervention
It retails for $650 but it cost me $300 for the shell used.
I just finished gutting. I did some test fit and the Ruger 10/22 can fit inside however my dremel isn't good enough to cut out the thick metals. I need to go to my gunsmith and have him mill out the receiver and the barrel since its faster and more precise. I'm likely going to cut my trigger guard off my 10/22 and use an extended trigger so I can use the existing trigger guard of the M200.
Also I'll be using a 29" barrel from urbanrifle.com. If it's too short, then I'll cut down the M200 barrel to match the length of the 10/22 barrel.
This thing is extremely heavy. I'll weigh it tomorrow but it feels like its about 20lbs without optics.
Right now its about 40% done. Hopefully the milling goes well when my gunsmith has time to work on it.
_MG_9999 by
defconskylude, on Flickr
_MG_9997 by
defconskylude, on Flickr
_MG_9996 by
defconskylude, on Flickr
_MG_9994 by
defconskylude, on Flickr
_MG_9992 by
defconskylude, on Flickr
_MG_9987 by
defconskylude, on Flickr
_MG_9986 by
defconskylude, on Flickr
_MG_9979 by
defconskylude, on Flickr