XD9SC First range report - Sights problem? - XDTalk Forums - Your HS2000/SA-XD Information Source!

IBJanky · 02-28-2006, 02:10 PM

I finally took out my XD9SC out to the range yesterday. I shot 200 of WWB through it, and every round fired fine without any hiccups.

I did notice a problem though, it seems that it shoots high and to the left

I'd shoot at the center of the target, and I would make a hole to the top and left of my point of aim

Are my sights off? If so, how do I go about in getting them adjusted? Do I have to send it back to SA?

Any info/help would be great. Thanks.

Camper · 02-28-2006, 03:50 PM

Quote:

Originally Posted by IBJanky

I finally took out my XD9SC out to the range yesterday. I shot 200 of WWB through it, and every round fired fine without any hiccups.

I did notice a problem though, it seems that it shoots high and to the left

I'd shoot at the center of the target, and I would make a hole to the top and left of my point of aim

Are my sights off? If so, how do I go about in getting them adjusted? Do I have to send it back to SA?

Any info/help would be great. Thanks.

Check out these links: http://www.targetshooting.ca/docs/Pi...t_Analysis.pdf. and this:http://makarov.com/funstuff.html.
Each new handgun and rifle takes some time to get used to and these target analysis charts should give you a start point. I had my SC9 out today and took a mag or two to get back in practice and it was then just as accurate as the Sig 228 I was also shooting.

Frashier · 02-28-2006, 07:01 PM

Be sure its not operator error before you adjust your sights.

IBJanky · 03-01-2006, 10:10 AM

Quote:

Originally Posted by Frashier

Be sure its not operator error before you adjust your sights.

I'm pretty sure it's not me because when I was shooting my .40cal SigPro that same day, I was blowing out the center all the time, but when I shot my XD9SC, I would blow out a hole that was high and left from the center

Frashier · 03-01-2006, 04:45 PM

Adjust your sights.

02-28-2006, 02:10 PM	#1
IBJanky XDTalk Member Join Date: Jan 2006 Posts: 42	XD9SC First range report - Sights problem? I finally took out my XD9SC out to the range yesterday. I shot 200 of WWB through it, and every round fired fine without any hiccups. I did notice a problem though, it seems that it shoots high and to the left I'd shoot at the center of the target, and I would make a hole to the top and left of my point of aim Are my sights off? If so, how do I go about in getting them adjusted? Do I have to send it back to SA? Any info/help would be great. Thanks.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

02-28-2006, 07:01 PM	#3
Frashier XDTalk Newbie Join Date: Feb 2006 Posts: 5	Be sure its not operator error before you adjust your sights.

03-01-2006, 04:45 PM	#5
Frashier XDTalk Newbie Join Date: Feb 2006 Posts: 5	Adjust your sights.