PowderRiver Trigger mod (video)

[Conceyted]

Originally Posted by Joeywhat

So would installing both the Powder River kit and the Springer trigger bar be basically a drop in job? I'm looking for the easiest solution...I don't mind throwing down a couple extra bones to not do any drilling.

Unfortunately, both the Powder River kit and the Springer trigger bar may need a SMALL bit of fitting. I had to go out and buy a 4 dollar round needle file and file down a piece of the lever that sat on the sear incorrectly. It is really straight forward though if you can follow some simple directions. the best part about the Powder River kit that I can see is that you don't have the risk of damaging the striker and striker safety like bob's and springer's kits do if you install them without fitting them.

[Joeywhat]

Originally Posted by Conceyted

Unfortunately, both the Powder River kit and the Springer trigger bar may need a SMALL bit of fitting. I had to go out and buy a 4 dollar round needle file and file down a piece of the lever that sat on the sear incorrectly. It is really straight forward though if you can follow some simple directions. the best part about the Powder River kit that I can see is that you don't have the risk of damaging the striker and striker safety like bob's and springer's kits do if you install them without fitting them.

Eh, some filing isn't a huge problem...as long as I'm not having to drill into anything. TBH I don't think my lame drill could even handle that.

I'll probably buy all this stuff today...never taken a gun apart this far, should be a good learning experience.