can someone measure stock sight depth real quick?

[miamisc2]

can someone do me a quick favor and measure how thick the stock rear sight is right where the white dots are? and the same for the front sight (from back of slide to front)

if possible, also from the notch to the sides (left to right or right to left) on the rear sight?

i need to know in millimeters. much appreciated.

[R Dub]

I no one else jumps in by tomorrow night (not really quick!) I can measure them when I return home. Just checking in from a break in fishing right now.

[miamisc2]

lol, at least i got one reply...thanks, i'd appreciate it.

[tomk]

Don't have a good way to measure precisely but my side-to-side measurement from the edge of the slot to the edge of the sight is 6mm.

Front to back is a lot harder since there's a taper. Mine are off the gun so I'm not sure where to measure. It's 6mm across the very bottom (the widest part of the sight - the part that at the bottom of the dovetail). The top of the sight is 2mm and the taper from bottom to top is roughly linear so you can figure out the measurement somewhere in the middle if you need to.

This is the sight off of a XD9SC.

Hope this helps.

[miamisc2]

that's exactly what i needed, thanks.