Trigger bar different. - XDTalk Forums - Your HS2000/SA-XD Information Source!

RLLOVER · 07-05-2005, 08:43 PM

So my Tactical has a trigger bar in it that looks like stamped steel with a pin pressed in the front to hold the trigger and trigger spring.

My sub-compact has a trigger bar that looks like a cast piece that is not uniform in thickness. It is not the same as the one pictured in the manual, the break down picks or in the store xd-HS2000.com. The part that touches the firing in safety lever is also different. It has a side plate on it.

Which one is the current version?

They cast piece works fine in either weapon?

Thanks again.

Randy

Zett · 07-06-2005, 07:25 AM

I noticed a difference between the transfer bar on my 5" vs. my 4" while banging my head against the wall trying to figure out how to modify the reset. The Tactical has an enclosed area where it engages the sear, the Service transfer bar is open at that section. Wierd.

-Zett

RIIID · 07-06-2005, 07:28 AM

The sheet metal one is the current one being used.
Rich

RLLOVER · 07-06-2005, 11:46 AM

That's too bad. The cast piece looks allot easier to modify, and allot stronger.

07-05-2005, 08:43 PM	#1
RLLOVER XDTalk Member Join Date: Mar 2005 Location: Central Ohio Posts: 93	Trigger bar different. So my Tactical has a trigger bar in it that looks like stamped steel with a pin pressed in the front to hold the trigger and trigger spring. My sub-compact has a trigger bar that looks like a cast piece that is not uniform in thickness. It is not the same as the one pictured in the manual, the break down picks or in the store xd-HS2000.com. The part that touches the firing in safety lever is also different. It has a side plate on it. Which one is the current version? They cast piece works fine in either weapon? Thanks again. Randy __________________ No matter how bad it is, it could always be worse... unless you\'re already on fire.

07-06-2005, 11:46 AM	#4
RLLOVER XDTalk Member Join Date: Mar 2005 Location: Central Ohio Posts: 93	That's too bad. The cast piece looks allot easier to modify, and allot stronger. __________________ No matter how bad it is, it could always be worse... unless you\'re already on fire.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

07-06-2005, 07:25 AM	#2
Zett XDTalk Member Join Date: Aug 2004 Location: Kennesaw, GA Posts: 39	I noticed a difference between the transfer bar on my 5" vs. my 4" while banging my head against the wall trying to figure out how to modify the reset. The Tactical has an enclosed area where it engages the sear, the Service transfer bar is open at that section. Wierd. -Zett

07-06-2005, 07:28 AM	#3
RIIID XDTalk Member Join Date: Jun 2003 Location: IL Posts: 98	The sheet metal one is the current one being used. Rich