|
|
|
|||||||
| Register | Forum Rules | Blogs | FAQ | Members List | Calendar | Search | Today's Posts | Mark Forums Read |
| XDTalk Memberships | Gold Sponsorships | XDTalk Sponsors | XDTalk Pro Logo Shop | Photo Gallery | Wiki | ChatBox |
|
Welcome to the XDTalk Forums - Your HS2000/SA-XD Information Source! forums. You are currently viewing our boards as a guest which gives you limited access to view most discussions and access our other features. By joining our free community you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Also, registering gets you started on gaining access to The Trading Post and Blogs after 30 days and 100 posts! Registration is fast, simple and absolutely free so please, join our community today! |
 |
|
|
LinkBack | Thread Tools | Display Modes |
03-22-2005, 11:52 PM
|
#1 |
|
XDTalk 500 Member
Join Date: Mar 2005
Location: Los Angeles, CA
Posts: 538
 |
HELPP!!! Gun won't disassemble = rod installed wrong!
Don HELLLP!
Hey i installed the guide rod improperly and now my gun won't dissassemble! I did not have access to the internet at the time so i went by memory from what i saw on pistol-gear.com... unfortunately i did a couple things wrong. I put the spring on backwards so that the double coil end is on the muzzle end and i added a washer on the back end of the rod. After putting it all together... it felt fine... but now i can't dissassemble. PLEASE HELP!!!
__________________
XD-40 Service Bi-Tone Glock 19 9mm SigSauer P220ST .45acp |
|
    
|
|
03-23-2005, 12:54 AM
|
#2 |
|
XDTalk 4K Member
 
Join Date: Mar 2001
Location: Pullman, WA
Posts: 4,268
|
PM sent,
It will be fine. 
|
|
|
|
03-23-2005, 11:57 AM
|
#3 |
|
XDTalk 500 Member
Join Date: Mar 2005
Location: Los Angeles, CA
Posts: 538
|
PRoblem fixed.
ANd for those who may search for this post later... this is what i did to undue it.... Since the misplaced washer at the back end of the rod is too large in diameter, it is causing the slide assembly(with guide rod and spring) to get caught on the take down lever. THe difference in diameter however is very minimally different between this and the diameter of the oem rod. So to get my slide off, i forcefully slapped the bottom of the reciever with my hand as i tried to push the slide forward.(Of course this is after i have already locked the slide back, raised the take down lever, rack the slide, pulled the trigger as per the normal disassembly procedure.) Man was i worried though.... Eric.
__________________
XD-40 Service Bi-Tone Glock 19 9mm SigSauer P220ST .45acp |
|
|
|
|
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
