Wasr 10 Fail to Fire??? - XDTalk Forums

robb01 · 10-08-2009, 03:41 PM

I was finally able to take out my new Romanian AK Wasr-10 yesterday, I shot probably 90 rounds through it, and had 3 fail to fires. I'm hoping this was just the ammo and not the gun. I thoroughly cleaned it before use and was using Wolf ammo, anyone else ever experience anything similiar?

**Se2002** · 10-08-2009, 03:43 PM

I had 1 out of 1000 where the primer was struck several times without firing. Consider it an ammo issue.

robb01 · 10-08-2009, 03:46 PM

thanks, Forget to mention that the primer was def. struck

zWarlord · 10-08-2009, 04:11 PM

ammo

Polymerhead · 10-08-2009, 07:58 PM

Quote:

Originally Posted by robb01

thanks, Forget to mention that the primer was def. struck

If the firing pin made a dimple as deep as on the fired cases, then yes - obviously an ammo issue!

meaty · 10-08-2009, 07:58 PM

Quote:

Originally Posted by zWarlord

ammo

+1

**einheit 13** · 10-08-2009, 08:11 PM

Be careful when you have a dud, recock it and hit it again. Then give it at least 30 seconds pointed in a safe direction. Eject it slowly and place it on the ground away from everyone. I know this may seem se3riously over kill...i've had a round go off after I have ejected it.

Chapie+ · 10-08-2009, 10:13 PM

Quote:

Originally Posted by einheit 13

Be careful when you have a dud, recock it and hit it again. Then give it at least 30 seconds pointed in a safe direction. Eject it slowly and place it on the ground away from everyone. I know this may seem se3riously over kill...i've had a round go off after I have ejected it.

A safety reminder (like yours above) could save eyes and lives!

Thank you!

Chapie+